Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor













Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.





3. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.





4. Remove the bolt and the TSS sensor.





Installation

1. Install the TSS sensor and the bolt.
- Tighten to 10 Nm (89 lb-in).





2. Connect the TSS sensor electrical connector.





3. Install the LH front structure-to-subframe splash shield and the 6 pin-type retainers.





4. Fill the transaxle with clean transmission fluid.





5. Start the engine and move the range selector lever into each gear position.

6. Using the scan tool with the engine running, check and make sure that the transmission is at normal operating temperature 85-93°C (185-200°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.