Audio Digital Signal Processing (DSP) Module

Audio Digital Signal Processing (DSP) Module

Sony(R) Sound









THX(R) Sound









Removal and Installation

NOTE: This procedure applies to Fusion/Milan with Sony(R) sound and MKZ with THX(R) sound only. For all other amplifiers, refer to the appropriate procedure.

1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.

Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Remove the 4 pushpins and the RH luggage compartment trim panel.

3. Disconnect the audio DSP module electrical connectors.

4. Remove the 3 bolts and the audio DSP module.
- To install, tighten to 9 Nm (80 lb-in).

5. To install, reverse the removal procedure.
- Download the configuration information to the audio DSP module. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).