Pinpoint Tests BB: The Turn Signal On Warning Chime Is Inoperative

Instrumentation, Message Center and Warning Chimes

Pinpoint Test BB: The Turn Signal On Warning Chime Is Inoperative

Normal Operation

The turn signal on warning chime sounds when the vehicle travels more than 3.2 km (2.0 miles) with the turn signal on. The Smart Junction Box (SJB) communicates the turn signal switch status to the Instrument Panel Cluster (IPC) over the Medium Speed Controller Area Network (MS-CAN). The IPC receives the odometer rolling count data from the PCM over the High Speed Controller Area Network (HS-CAN).

This pinpoint test is intended to diagnose the following:

- Odometer operation
- IPC


PINPOINT TEST BB: THE TURN SIGNAL ON WARNING CHIME IS INOPERATIVE

-------------------------------------------------
BB1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION

- Ignition OFF.
- Insert the key into the ignition lock cylinder.
- Open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?

Yes
GO to BB2.

No
GO to Pinpoint Test AY (chime is always on) or GO to Pinpoint Test AZ (chime is inoperative). Pinpoint Tests AY: The Chime Sounds When The Driver Door Is Ajar (No Key In Ignition And Headlamps Off) Pinpoint Tests AZ: The Key-In-Ignition Warning Chime Is Inoperative

-------------------------------------------------
BB2 CHECK THE TURN SIGNAL INDICATORS OPERATION

- Ignition ON.
- Verify the turn signal indicators operation.
- Do the turn signal indicators operate correctly?

Yes
GO to BB3.

No
GO to Pinpoint Test AB. Pinpoint Tests AB: The LH/RH Turn Or High Beam Indicator Is Never/Always On

-------------------------------------------------
BB3 CHECK THE ODOMETER FOR CORRECT OPERATION

- Drive the vehicle and observe the odometer for correct operation.
- Does the odometer operate correctly?

Yes
INSTALL a new SJB. REFER to Multifunction Electronic Modules Service and Repair. TEST the system for normal operation.

No
GO to Pinpoint Test H. Pinpoint Test H: The Odometer Is Inoperative

-------------------------------------------------