Wheel Speed Sensor - Front

Wheel Speed Sensor - Front









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the fender splash shield. For additional information, refer to Front End Body Panels Fender Splash Shield.

3. Disconnect the wheel speed sensor electrical connector.

4. Remove the wheel speed sensor harness bracket-to-body bolt.
- To install, tighten to 7 Nm (62 lb-in).

5. Detach the wheel speed sensor harness from the wheel knuckle bracket.

6. Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).

7. To install, reverse the removal procedure.