Resonator: Service and Repair

Intake Air Resonator

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the LH fender splash shield. For additional information, refer to Front End Body Panels Fender Splash Shield.

3. Remove the 3 nuts and the air intake resonator.
- To install, tighten to 15 Nm (133 lb-in).

4. NOTE: Make sure that the Air Cleaner (ACL) inlet pipe is securely seated to the intake air resonator.

To install, reverse the removal procedure.