Pinpoint Tests BJ: DTC U0111:00

Instrumentation, Message Center and Warning Chimes

Pinpoint Test BJ: DTC U0111:00

Normal Operation
- DTC U0111:00 (Lost Communication With Battery Energy Control Module "A": No Sub-Type Information) - sets in the Instrument Panel Cluster (IPC) if data messages received from the Battery Pack Sensor Module (BPSM) over the High Speed Controller Area Network (HS-CAN) are missing for greater than 5 seconds. For a complete list of all network messages, refer to Module Communications Network Testing and Inspection.

This pinpoint test is intended to diagnose the following:

- BPSM
- IPC


PINPOINT TEST BJ: DTC U0111:00

-------------------------------------------------
BJ1 VERIFY THE CUSTOMER CONCERN

- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to BJ2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
BJ2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test .
- Carry out the network test.
- Does the BPSM pass the network test?

Yes
GO to BJ3.

No
REFER to Module Communications Network Testing and Inspection.

-------------------------------------------------
BJ3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST

- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?

Yes
GO to Pinpoint Test BX (U3003:16) or GO to Pinpoint Test BY (U3003:17). Pinpoint Tests BX: DTC U3003:16 Pinpoint Tests BY: DTC U3003:17

No
GO to BJ4.

-------------------------------------------------
BJ4 RECHECK THE IPC DTCs

NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the IPC self-test.
- Is DTC U0111:00 still present?

Yes
GO to BJ5.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
BJ5 CHECK FOR DTC U0111 SET IN OTHER MODULES

- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test .
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0111 set in the PCM?

Yes
INSTALL a new BPSM. REFER to High Voltage Traction Battery . CLEAR the DTCs. REPEAT the self-test.

No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

-------------------------------------------------