Pinpoint Test M: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter

Handles, Locks, Latches and Entry Systems

Pinpoint Test M: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter

Normal Operation

When any Integrated Keyhead Transmitter (IKT) button is pressed, the SJB receives and processes the command to provide the appropriate output.

This pinpoint test is intended to diagnose the following:

- Door locks
- Horn system
- Luggage compartment lid release
- Turn signal system
- IKT


PINPOINT TEST M: AN INDIVIDUAL BUTTON/FEATURE IS INOPERATIVE FROM THE RKE TRANSMITTER

NOTE: The panic feature will only operate when the key is in the OFF or LOCK positions.

-------------------------------------------------
M1 VERIFY THE DOOR LOCK OPERATION

- Press the lock and unlock button on the driver door lock control switch while observing the door lock operation.
- Do the door locks operate correctly?

Yes
GO to M2.

No
GO to Symptom Chart - Electrical. Symptom Chart - Electrical

-------------------------------------------------
M2 VERIFY THE HORN OPERATION

- Enter the following diagnostic mode on the scan tool: SJB DataLogger .
- Select the SJB PID (HORN) and active command the horn on.
- Does the horn sound when commanded on?

Yes
GO to M3.

No
REFER to Horn Testing and Inspection.

-------------------------------------------------
M3 VERIFY THE HAZARD LAMP OPERATION

- Place the hazard switch in the ON position.
- Do the hazard lamps operate correctly?

Yes
GO to M4.

No
REFER to Exterior Lighting Testing and Inspection.

-------------------------------------------------
M4 VERIFY THE LUGGAGE COMPARTMENT LID RELEASE OPERATION

- Press the luggage compartment lid release button, located next to the headlamp switch.
- Does the luggage compartment lid release?

Yes
REPLACE the inoperative IKT and PROGRAM the IKT individually or PROGRAM all the IKTs. REFER to Anti-Theft - Passive Anti-Theft System (PATS) Programming and Relearning for the programming procedures. If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed. TEST the system for normal operation.

No
GO to Symptom Chart - Electrical. Symptom Chart - Electrical

-------------------------------------------------