Extension Housing Seal

Extension Housing Seal









Removal

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury. Procedures

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the driveshaft. For additional information, refer to Driveshaft Removal and Replacement.

3. Using the Transmission Fluid Seal Remover and Slide Hammer, remove the extension housing seal.





Installation

1. NOTE: When installing the new seal, make sure that the drain hole in the seal is in the 6 o'clock position.

Using the Transmission Extension Housing Oil Seal Installer, install a new extension housing seal.





2. Install the driveshaft. For additional information, refer to Driveshaft Removal and Replacement.

3. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury. Description and Operation

Check the level of the transmission fluid. Add transmission fluid as necessary.