Pinpoint Test R: The Traction Control Indicator Is Never/Always On (If Equipped)

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test R: The Traction Control Indicator Is Never/Always On (If Equipped)

Normal Operation

The traction control indicator informs the driver that a traction control event is taking place, by flashing the traction control indicator during the event. The traction control indicator illuminates constantly when a malfunction is detected in the traction control system, or if the traction control system is disabled by the operator. The ABS module monitors the traction control event and sends the Instrument Cluster (IC) a Controller Area Network (CAN) message to illuminate the traction control indicator.

This pinpoint test is intended to diagnose the following:

- ABS module
- IC

PINPOINT TEST R: THE TRACTION CONTROL INDICATOR IS NEVER/ALWAYS ON (IF EQUIPPED)

-------------------------------------------------
R1 RETRIEVE THE RECORDED DTCs FROM THE ABS MODULE SELF-TEST


- Check for recorded ABS module DTCs from the self-test.
- Are any DTCs recorded?

Yes
REFER to Vehicle Dynamic Systems Testing and Inspection to continue diagnosis of the ABS system.

No
GO to R2.

-------------------------------------------------
R2 CARRY OUT THE IC INDICATOR LAMP ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger .
- Select the IC traction control indicator (ACTIVELMP) active command on and off. Observe the traction control indicator.
- Does the traction control indicator illuminate when selected on and turn off when selected off?

Yes
INSTALL a new ABS module. REFER to Vehicle Dynamic Systems Service and Repair. TEST the system for normal operation.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------