Upper Side Moulding / Trim: Service and Repair

Body Side Moulding









NOTICE: Body side molding installation should not be attempted on vehicle with surface temperatures below 21° C (70° F) or adhesion problems could occur.

1. NOTICE: The vehicle body must be clean prior to installation of an adhesive backed body side molding.

Wash and dry the vehicle exterior.

2. NOTE: The use of a small amount of heat may aid in removal of adhesive backed moldings do not exceed 52° C (125° F).

If installed, carefully remove the adhesive-back body side molding.

3. NOTICE: Do not use sharp objects or metal-bladed putty knives for removal as damage to paint could occur.

Remove all remaining adhesive from the vehicle body.

4. Clean the area with a commercially available wax and grease remover.
- Re-clean the area using a commercially available alcohol cleaner

5. NOTICE: Do not exceed 52° C (125° F) or damage to the molding could occur.

If the molding is curled or distorted it may be brought back to correct shape when warmed.

6. Warm the moldings evenly on a flat surface prior to installation using a heat gun.
- Temperature range should not exceed 38° C (100° F) - 52° C (125° F)

7. Remove the adhesive tape liner from the body side molding.

8. Properly position the molding to the vehicle and apply firm pressure to the entire molding until fully adhered to the vehicle body.