Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module









Removal and Installation

NOTICE: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to these charges.

1. NOTE: When installing a new ABS module, it must be configured using vehicle as-built data.

Remove the Hydraulic Control Unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) Service and Repair.

2. Remove and discard the 4 screws.
- To install, tighten the new screws to 3 Nm (27 lb-in).

3. Remove the ABS module.

4. To install, reverse the removal procedure.