Parking Brake Cable - Intermediate

Parking Brake Cable - Intermediate

Removal and Installation

1. Relieve the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release Procedures.

2. Remove the 3 parking brake cable bracket bolts from the subframe.
- To install, tighten to 12 Nm (106 lb-in).

3. Disconnect the intermediate cable from the front cable at the cable-to-cable union.

4. Release the intermediate cable from the body bracket.

5. Release the intermediate cable from the rear RH cable at the cable-to-cable union.

6. Release the LH rear cable from the intermediate cable at the conduit equalizer.

7. To install, reverse the removal procedure.
- Inspect the parking brake system for correct operation.