Brake Caliper Anchor Plate

Brake Caliper Anchor Plate

Removal

1. Remove the brake pads. For additional information, refer to Brake Pads Brake Pads.

2. Remove and discard the 2 brake caliper anchor plate bolts and remove the brake caliper anchor plate.
- Make sure the steering stop is supported when the brake caliper anchor plate bolts are removed.

3. NOTE: Do not remove the anchor plate guide pins. The guide pins are press fit to the brake caliper anchor plate. If the guide pins are damaged, a new anchor plate must be installed.

Inspect the brake caliper anchor plate assembly.

- Check the guide pins and boots for binding or damage.

- Install a new brake caliper anchor plate if it is worn or damaged.

Installation

1. Position the brake caliper anchor plate and steering stop on the wheel knuckle and install 2 new bolts.
- Tighten to 150 Nm (111 lb-ft).

2. Install the brake pads. For additional information, refer to Brake Pads Brake Pads.