Seat Cushion - Rear

Seat Cushion - Rear, Taurus, Sable









Removal and Installation

1. From under the front of the cushion assembly, push each of the 2 seat cushion floor latch release levers to the left of the vehicle. Lift up at the front and release the front of the cushion assembly.

2. Push the cushion assembly back as far as possible. Lift up at the rear outboard ends of the cushion assembly, clearing the retainer hooks from the cushion assembly wire, pull the cushion assembly forward and remove it.

3. To install, reverse the removal procedure.
- Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.