Pinpoint Test A: The Roof Opening Panel Has Excessive Wind Noise

Roof Opening Panel

Pinpoint Tests

Pinpoint Test A: The Roof Opening Panel Has Excessive Wind Noise

Normal Operation

When the roof opening panel glass is completely closed, it is flush with the roof panel.

This pinpoint test is intended to diagnose the following:
- Roof opening panel adjustment
- Roof opening panel seal/weatherstrip
- Roof opening panel and motor/module



PINPOINT TEST A: THE ROOF OPENING PANEL HAS EXCESSIVE WIND NOISE

-------------------------------------------------
A1 VERIFY ROOF OPENING PANEL NOISE


- Road test the vehicle with the roof opening panel in the CLOSED and OPEN positions.
- Is the wind noise present only in the OPEN position?

Yes
GO to A4.

No
GO to A2.

-------------------------------------------------
A2 CHECK THE ROOF OPENING PANEL WEATHERSTRIP


NOTE: Make sure the weatherstrip is secured to the glass, not cut, cracked, pinched, loose or obstructed in CLOSED, VENT and OPEN positions.

- Check the roof opening panel weatherstrip.
- Is the roof opening panel weatherstrip OK?

Yes
GO to A3.

No
INSTALL a new roof opening panel weatherstrip. REFER to Roof Opening Panel - Exploded View Roof Opening Panel - Exploded View. TEST the system for normal operation.

-------------------------------------------------
A3 CHECK ROOF OPENING PANEL ADJUSTMENT


- Check the roof opening panel adjustment.
- Is the adjustment OK?

Yes
CHECK for correct installation of the roof opening panel and motor/module. REFER to Roof Opening Panel - Exploded View Roof Opening Panel - Exploded View, Roof Opening Panel Frame Roof Opening Panel Frame and Roof Opening Panel Motor Roof Opening Panel Motor. TEST the system for normal operation.

No
ADJUST the roof opening panel. REFER to Roof Opening Panel Alignment Roof Opening Panel Alignment. TEST the system for normal operation.

-------------------------------------------------
A4 CHECK THE AIR DEFLECTOR


- Make sure the air deflector is securely attached and check for damaged or unsecured springs.
- Is the air deflector OK?

Yes
PARTIALLY close the roof opening panel until the noise is eliminated. If the noise is eliminated, INFORM the customer that changing glass location will eliminate the wind noise. If the wind noise is not eliminated, READJUST panel. TEST the system for normal operation.

No
INSTALL new air deflector assembly. REFER to Roof Opening Panel - Exploded View Roof Opening Panel - Exploded View and Air Deflector Air Deflector. TEST the system for normal operation.

-------------------------------------------------