Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor





Turbine Shaft Speed (TSS) Sensor









Removal

1. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.





2. Remove the bolt and the TSS sensor.
- To install, tighten to 10 Nm (89 lb-in).

- Check the TSS sensor bore.

- Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.





Installation

1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.

NOTE: Apply thread sealant to the bolt.

To install, reverse the removal procedure.