FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Diagnostic Strategy




Diagnostic Strategy

NOTE: Do not take any shortcuts or assume that critical checks or adjustments have already been made.

Troubleshooting an electronically controlled automatic transaxle is simplified by using the proven method of diagnosis. One of the most important things to remember is that there is a definite procedure to follow.

Follow the procedures as written to avoid missing critical components or steps.

To correctly diagnose a concern, have the following publications available:

- Computers and Control Systems Information
- TSBs
- Wiring Diagram

These publications provide the necessary information when diagnosing transaxle concerns.

Use the Diagnostic Flow Chart as a guide and follow the steps as indicated.


Preliminary Inspection

- Know and understand the customers concern.
- Verify the concern by operating the vehicle.
- Check the transmission fluid level and condition.
- Check for non-factory add-on items.
- Check the selector lever linkage for correct adjustment.
- Check TSBs regarding the concern.


Diagnostics

- Carry out On-Board Diagnostic (OBD) procedures Key ON Engine OFF (KOEO) and Key ON Engine Running (KOER).
- Record all DTCs.
- Repair all non-transaxle codes first.
- Repair all transaxle codes second.
- Erase all continuous codes and attempt to repeat them.
- Repair all continuous codes.
- If only pass codes are obtained, proceed to Diagnosis By Symptom Diagnosis By Symptom for further information and diagnosis.

Follow the diagnostic sequence to diagnose and repair the concern the first time.