Heated Oxygen Sensor (HO2S)

Heated Oxygen Sensor (HO2S)









Removal and Installation

Rear sensor

1. With the vehicle in NEUTRAL, position it on a hoist.

Both sensors

2. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.

3. NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.

Using the Exhaust Gas Oxygen Sensor Socket, remove the HO2S.

- To install, tighten to 48 Nm (35 lb-ft).





4. NOTE: Apply a light coat of anti-seize lubricant to the threads of the HO2S.

To install, reverse the removal procedure.