Pinpoint Tests AM: The Safety Belt Warning Chime Does Not Operate Correctly/The Belt-Minder(R) Feature Does Not Operate Correct
Instrumentation, Message Center and Warning Chimes
Pinpoint Test
Pinpoint Test AM: The Safety Belt Warning Chime Does Not Operate Correctly/The Belt-Minder(R) Feature Does Not Operate Correctly
Normal Operation
The Instrument Cluster (IC) receives the safety belt and Belt-Minder(R) requests from the Restraints Control Module (RCM) over the High Speed Controller Area Network (HS-CAN). The safety belt warning chime sounds for approximately 6 seconds when the driver safety belt is not fastened and the ignition lock cylinder is turned from the OFF/LOCK or ACC to the ON or START position.
The Belt-Minder(R) feature supplements the safety belt warning function and is enabled after the safety belt warning is complete. The Belt-Minder(R) reminds the driver that the driver or passenger safety belt is unbuckled by intermittently sounding a chime and illuminating the safety belt warning lamp in the IC once the vehicle speed has exceeded 5 km/h (3 mph), and remains active for 5 minutes from the time it is started. While activated, the Belt-Minder(R) alternates the chime and indicator from on for 6 seconds to off for 30 seconds.
NOTE: Make sure that the safety belt/Belt-Minder(R) chime operation is verified with the vehicle moving at least 5 km/h (3 mph).
This pinpoint test is intended to diagnose the following:
- Safety belt warning indication concern
- Belt-Minder(R) deactivated
- Speedometer concern
- IC
PINPOINT TEST AM: THE SAFETY BELT WARNING CHIME IS INOPERATIVE/THE BELT-MINDER(R) FEATURE DOES NOT OPERATE CORRECTLY
-------------------------------------------------
AM1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- With the ignition switch in the OFF position and the key in the ignition lock cylinder, open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
Yes
GO to AM2.
No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.
-------------------------------------------------
AM2 CHECK THE SAFETY BELT WARNING INDICATOR FOR CORRECT OPERATION
- Ignition ON.
- Buckle then unbuckle the LH front safety belt.
- Verify the safety belt warning indicator illuminates with the safety belt unbuckled and turns off when buckled.
- Does the safety belt warning indicator operate correctly?
Yes
GO to AM3.
No
Go To Pinpoint Test L. Pinpoint Test L: The Safety Belt Warning Indicator Is Never/Always On
-------------------------------------------------
AM3 CHECK THE SPEEDOMETER OPERATION
- Verify that the speedometer is operating correctly.
- Does the speedometer operate correctly?
Yes
GO to AM4.
No
Go To Pinpoint Test F. Pinpoint Test F: The Speedometer/Odometer Is Inoperative
-------------------------------------------------
AM4 CHECK THE BELT-MINDER(R) CONFIGURATION
- Verify that the Belt-Minder(R) is activated or configured on for the seating position in question. Refer to Belt-Minder(R) Deactivating/Activating Service and Repair to configure without a scan tool.
- Is the Belt-Minder(R) activated for the seating position in question?
Yes
INSTALL a new RCM. REFER to Air Bag Systems. TEST the system for normal operation.
No
ACTIVATE the Belt-Minder(R) for the seating position in question. REFER to Belt-Minder(R) Deactivating/Activating Service and Repair. TEST the system for normal operation.
-------------------------------------------------