Pinpoint Test R: The Anti-Theft Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test R: The Anti-Theft Indicator Is Never/Always On

Normal Operation

The anti-theft indicator proves out for 3 seconds when the key is turned to the ON or START position under normal operation. If there is a Passive Anti-Theft System (PATS) concern, the anti-theft indicator either flashes rapidly or glows steadily (for more than 3 seconds) when the key is turned to the ON or the START position. PATS also flashes the anti-theft indicator every 2 seconds at key off to act as a visual theft deterrent. The anti-theft indicator operation is controlled by the Instrument Cluster (IC).

This pinpoint test is intended to diagnose the following:

- PATS concern
- IC



PINPOINT TEST R: THE ANTI-THEFT INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
R1 CARRY OUT THE IC ANTI-THEFT INDICATOR ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger.
- Select the IC anti-theft indicator (THEFT_LMP) active command. Command the anti-theft indicator on and off. Observe the anti-theft indicator.
- Does the anti-theft indicator illuminate when commanded on, and turn off when commanded off?

Yes
GO to R2.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------
R2 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST


- Check for recorded continuous memory IC DTCs.
- Are any PATS related DTCs recorded?

Yes
REFER to Antitheft and Alarm Systems.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------