Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module









Removal and Installation

NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.

NOTICE: Do not allow any brake fluid or foreign material to enter the mating side of the Anti-lock Brake System (ABS) module or damage to the solenoids can occur.

1. If a new ABS module is being installed, connect the scan tool and upload the module configuration from the ABS module.

2. Remove the degas bottle.

3. Disconnect the ABS module electrical connector.

4. Remove the 3 ABS module screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).

5. NOTE: Visually inspect the ABS module terminals for damage before installation.

To install, reverse the removal procedure.

6. If a new ABS module was installed, download the module configuration information from the scan tool.