Throttle Body: Service and Repair

Throttle Body









1. Remove the air cleaner outlet pipe.

2. Disconnect the electronic throttle control electrical connector.

3. Release the Throttle Body (TB) coolant inlet hose clamp.
- Disconnect and plug the hose.

4. Release the TB coolant outlet hose clamp.
- Disconnect and plug the hose.

5. Remove the 4 bolts and the TB.
- Discard the TB gasket.

- To install, tighten to 10 Nm (89 lb-in).

6. NOTE: Install a new TB gasket.

To install, reverse the removal procedure.