Pinpoint Tests AB: DTC B1318
Instrumentation, Message Center and Warning Chimes
Pinpoint Tests
Pinpoint Test AB: DTC B1318
Refer to Wiring Diagram Set 60, Instrument Cluster for schematic and connector information. Diagrams By Number
Normal Operation
- DTC B1318 (Battery Voltage Low) - a continuous memory and on-demand DTC that sets in the Instrument Cluster (IC) if the IC detects battery voltage below 9 volts on the B+ keep alive voltage input circuit SBP07 (WH/RD).
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- High circuit resistance
- IC
PINPOINT TEST AB: DTC B1318
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
AB1 RECHECK THE IC DTCs
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC Self-Test.
- Clear the DTCs. Repeat the IC self-test.
- Is DTC B1318 still present?
Yes
GO to AB2.
No
The system is operating correctly at this time. The DTC may have been set due to a previous low battery voltage condition.
-------------------------------------------------
AB2 CHECK THE CHARGING SYSTEM DTCs IN THE PCM
- Enter the following diagnostic mode on the scan tool: PCM Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC P0620, P0622, P0625, P0626 or P065B set in the PCM?
Yes
REFER to Charging System.
No
GO to AB3.
-------------------------------------------------
AB3 CHECK THE BATTERY CONDITION AND STATE OF CHARGE
- Check the battery condition and verify that the battery is fully charged. Refer to Battery.
- Is the battery OK and fully charged?
Yes
GO to AB4.
No
REFER to Battery.
-------------------------------------------------
AB4 CHECK THE IC VOLTAGE SUPPLY
- Ignition OFF.
- Measure and record the voltage at the battery.
- Disconnect: IC C220.
- Ignition ON.
- Measure the voltage between the IC C220-19, circuit SBP07 (WH/RD), harness side and ground.
- Is the voltage within 0.2 volt of the recorded battery?
Yes
GO to AB5.
No
REPAIR the circuit for high resistance. CLEAR the DTC. REPEAT the self-test.
-------------------------------------------------
AB5 CHECK THE IC GROUND CIRCUITS
- Ignition OFF.
- Disconnect: Negative Battery Cable.
- Measure the resistance between the IC C220-9, circuit GD116 (BK/VT), harness side and ground; and between the IC C220-10, circuit GD116 (BK/VT), harness side and ground.
- Are the resistances less than 5 ohms?
Yes
GO to AB6.
No
REPAIR the circuit for high resistance. TEST the system for normal operation.
-------------------------------------------------
AB6 CHECK FOR CORRECT IC OPERATION
- Disconnect the IC connector.
- Check for:
- corrosion
- damaged pins
- pushed-out pins
- Connect the IC connector and make sure it seats correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?
Yes
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
-------------------------------------------------