Instrument Cluster (IC)

Instrument Cluster (IC)









Removal and Installation

1. NOTE: If installing a new Instrument Cluster (IC), it is necessary to upload the IC configuration information to the scan tool.
Remove the IC finish panel.

2. Depower the Supplemental Restraint System (SRS). For additional information, refer to Air Bag Systems.

3. NOTE: Release the upper steering column shroud by pressing the sides inward.

Remove the upper steering column shroud.

4. Remove the screw and the transmission range indicator from the steering column.
- Disconnect the transmission range indicator cable from the shift selector arm.

5. Remove the 4 screws and the IC.
- Disconnect the electrical connector.

6. To install, reverse the removal procedure.
- If a new IC was installed, download the IC configuration information from the scan tool into the new IC.