Brake Caliper Anchor Plate

Brake Caliper Anchor Plate

Removal and Installation

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury. Procedures
With the vehicle in NEUTRAL, position it on a hoist.

2. Disconnect the rear parking brake cable and conduit.

3. Remove the axle shaft.

4. WARNING: Use tools, not fingers, to hold flagnuts. Flagnuts may slip or spin unexpectedly when removing fasteners. Failure to follow this instruction may result in injured fingers.
Remove the 4 retainers and the brake caliper anchor plate.
- To install, tighten to 68 Nm (50 lb-ft).

5. To install, reverse the removal procedure.

6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury. Procedures
If equipped with a fire suppression system, repower the system.