Drive/Propeller Shaft: Service and Repair

Driveshaft

Driveshaft (Part 1):

Driveshaft (Part 2):

Removal and Installation

NOTE: Index-mark both driveshaft flanges.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the muffler and tailpipe.
3. Remove the 4 exhaust support brace bolts and the exhaust brace.
^ To install, tighten to 30 Nm (22 lb-ft).

4. CAUTION: Do not reuse the bolt and washer assemblies for the rear constant velocity (CV) joint flange. Install new assemblies or damage to the vehicle may occur.

Remove and discard the 3 CV joint flange bolt and washer assemblies.
^ To install, tighten to 70 Nm (52 lb-ft).





5. CAUTION: Do not reuse the constant velocity (CV) joint bolts. Install new bolts or damage to the vehicle may occur.

Remove and discard the 4 driveshaft-to-transfer case bolts.
^ To install, tighten to 70 Nm (52 lb-ft).





6. With the help of an assistant, remove the 2 center bearing bracket bolts and the driveshaft.
^ To install, tighten to 30 Nm (22 lb-ft).





7. If necessary, remove the 2 center bearing bolts and remove the bracket.
^ To install, tighten to 20 Nm (15 lb-ft).

8. NOTE: If a driveshaft is installed and driveshaft vibration is encountered after installation, index the driveshaft.

To install, reverse the removal procedure.