Seat Position Sensor: Service and Repair

SEAT POSITION SENSOR







Removal and Installation

WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Power seat track seat position sensor shown, manual seat track position sensor similar.
- The seat must be in rearward position.
- LH shown, RH similar.

1. Position the seat to access all the seat track-to-floor pan bolts and the safety belt anchor.
2. Depower the SRS.
3. Remove the seat.
4. Disconnect the seat position sensor electrical connector.
5. Drill out the 2 seat position sensor rivets.
6. Remove the seat position sensor.
7. To install, reverse the removal procedure.
8. Repower the SRS.