Seat Control Switch - Front

SEAT CONTROL SWITCH - FRONT

Exploded View

Front Seat Backrest (Part 1):

Front Seat Backrest (Part 2):

Driver Front Seat Cushion (Part 1):

Driver Front Seat Cushion (Part 2):

Passenger Front Seat Cushion (Part 1):

Passenger Front Seat Cushion (Part 2):

Removal and Installation

WARNING:
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
- To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraint control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS.
2. If equipped, pull out and remove the manual recline handle.
3. If equipped, remove the seat control switch knob and power recline knob.
4. Remove the rear screw, pull out on the side and front and separate the side shield.
5. Release the seat control switch wire harness pin-type retainer and remove the seat control switch from the side shield. Disconnect and remove the seat control switch.
6. To install, reverse the removal procedure.
7. Repower the SRS.