Exhaust Crossover Pipe: Service and Repair

Exhaust Y-Pipe

Removal and Installation

1. NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.

With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the 4 exhaust Y-pipe-to-LH and RH catalytic converter nuts.
^ Discard the gaskets.
^ To install, tighten to 40 Nm (30 lb-ft).
3. Remove and discard the exhaust Y-pipe flange nuts and remove the exhaust Y-pipe.
^ Discard the gasket.
^ To install, tighten to 40 Nm (30 lb-ft).
4. To install, reverse the removal procedure.
^ Install new gaskets and nuts.
5. Start the engine and check for exhaust leaks.