Programming and Relearning
ROOF OPENING PANEL MOTOR INITIALIZATIONWARNING: Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.
NOTE:
- A new roof opening panel motor will only vent and must be initialized.
- The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel motor has been removed from the roof opening panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed.
1. Turn the ignition to the RUN position. For a new roof opening panel motor, skip to Step 3.
2. For an existing roof opening panel motor, use the close switch to open the roof opening panel glass to the full VENT position.
3. For a new roof opening panel motor, press and hold the close switch until the roof opening panel glass moves past full VENT and suddenly back to full VENT.
For an existing motor, press and hold the close switch (for approximately 10 seconds) until the roof opening panel glass moves past full VENT and suddenly back to full VENT.
4. Quickly release the close switch and re-press and hold the close switch while the roof opening panel glass moves to full OPEN and back to CLOSED (movement will start approximately 3 seconds after the switch is pressed).
5. Release the switch and verify successful initialization by carrying out one-touch OPEN, one-touch CLOSE and VENT operations.