FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Rear Door: Service and Repair

DOOR







Removal and Installation
1. Disconnect the front door electrical connector at the A-pillar.
2. Remove the door check bolts.
- To install, tighten to 25 Nm (18 lb-ft).

3. CAUTION:
- To minimize the possibility of cross threading, hand start all fasteners during installation.
- To avoid damaging the door, this step requires an assistant.


With a wax pencil, mark the position of each hinge and remove the hinge-to-door bolts.
- To install, tighten to 30 Nm (22 lb-ft).

4. Remove the front door.

5. NOTE: If installing a new door, transfer parts as necessary.

To install, reverse the removal procedure.
- Verify door adjustment. For additional information, refer Door Adjustment - Front or Door Adjustment - Rear. Adjustments Adjustments