Disc Removal and Installation, Rear

Brake Disc

Disc Brake System - Exploded View (Part 1):

Disc Brake System - Exploded View (Part 2):

Removal and Installation
1. Remove the wheel and tire.

2. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.

Remove the brake caliper anchor plate bolts and discard. Position the brake caliper anchor plate aside.
^ To install, tighten to 110 Nm (81 lb-ft).
3. Remove and discard the brake disc screw.
^ To install, tighten to 21 Nm (15 lb-ft).
4. Remove the brake disc.
5. To install, reverse the removal procedure, using 2 new brake caliper anchor plate bolts.