Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor

Material:

Output Shaft Speed (OSS) Sensor:

Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Place a drain pan beneath the output shaft speed (OSS) sensor.
3. Remove the OSS sensor.
^ Disconnect the electrical connector.
^ Remove the bolt.
^ Inspect the OSS bore.





4. Inspect the O-ring seal for nicks or cuts, install a new O-ring if necessary.





Installation

1. NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.

Install the OSS sensor.
^ Tighten to 10 Nm (89 lb-in).
^ Connect the electrical connector.





2. Check the transmission fluid level and add transmission fluid as necessary.





3. Start the engine and move the selector lever through all gear positions.