Front Door: Service and Repair

DOOR







Removal and Installation
1. Remove the door check arm-to-body bolt.
- To install, tighten to 25 Nm (18 lb-ft).

2. CAUTION:
- To minimize the possibility of cross threading, hand start all fasteners during the installation.
- To avoid damaging the door, this step requires an assistant.

Mark the position of each hinge and remove the hinge-to-door bolts.
- To install, tighten to 30 Nm (22 lb-ft).

3. Remove the front door.
4. To install, reverse the removal procedure.
- If necessary, align the door. For additional information, refer to Door Alignment - Front or Door Alignment - Rear. Adjustments Adjustments