Side Impact Sensor - B-Pillar

SIDE IMPACT SENSOR - B-PILLAR







WARNING: Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the safety canopy and cause serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- RH shown, LH similar.
- Seat and carpet removed for clarity.

1. Depower the SRS.
2. Remove the front door scuff plate trim panel.
3. Remove the rear door scuff plate trim panel.
4. Remove the lower B-pillar trim panel.
- Slide the lower B-pillar trim panel down to disengage it from the upper B-pillar trim panel.

5. Disconnect the side impact sensor electrical connector.

6. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.

NOTE:
- Make sure the B-pillar and side impact sensor mating surfaces are clean and free of foreign material.
- Note position of the sensor and locating tab for installation.

Remove the bolt and side impact sensor.
- To install, tighten to 12 Nm (9 lb-ft).

7. To install, reverse the removal procedure.
8. Repower the SRS.