Information Bus: Description and Operation
COMMUNICATIONS NETWORKNOTE: The smart junction box (SJB) is also known as the generic electronic module (GEM).
Vehicle communication utilizes both medium and high speed controller area network (CAN) communications. CAN is used for many modules to communicate with each other on a common network. CAN in-vehicle networking is a method for transferring data among distributed electronic modules using a serial data bus. Without serial networking, intermodule communication requires dedicated, point to point wiring resulting in bulky, expensive, complex, and difficult to install wiring harnesses. Applying a serial data network reduces the number of wires, thereby combining the signals on a single network. Information is sent to the individual control modules that control each function.
The vehicle has 2 module communication networks:
- Medium speed (MS) CAN
- High speed (HS) CAN
Both networks are connected to the data link connector (DLC), located under the dash. This makes diagnosis and testing of these systems easier by allowing one scan tool to be able to diagnose and control any module on both networks from one connector. The DLC can be found under the instrument panel between the steering column and the audio control module (ACM).
Network Topology:
MS-CAN Operation
The MS-CAN communicates using bussed messages. The MS-CAN has an unshielded twisted pair cable, data bus (+) and data bus (-) circuits. In addition to scan tool communication, this network allows sharing of information between all modules on the network.
The MS-CAN is a medium speed communication network used for the following modules:
- Accessory protocol interface module (APIM) (if equipped)
- Audio control module (ACM)
- Audio digital signal processing (DSP) module (if equipped)
- Driver door module (DDM) (if equipped)
- Driver seat module (DSM) (if equipped)
- Dual climate control seat module (DCSM) (if equipped)
- Heating ventilation air conditioning (HVAC) module
- Instrument cluster (IC)
- Parking aid module (PAM)
- Satellite digital audio receiver system (SDARS) module (if equipped)
- Smart junction box (SJB)
HS-CAN Operation
The HS-CAN communicates using bussed messages. The HS-CAN uses an unshielded twisted pair cable, data bus (+) and data bus (-) circuits. In addition to scan tool communication, this network allows sharing of information between all modules on the network.
The HS-CAN is a high speed communication network used for the following modules:
- Accessory protocol interface module (APIM) (if equipped)
- ABS module
- Instrument cluster (IC)
- Occupant classification system module (OCSM)
- PCM
- Restraints control module (RCM)
- Transmission control module (TCM) (if equipped)
- 4X4 control module
Network Termination
The CAN uses a network termination circuit to improve communication reliability. The network termination of the CAN bus takes place inside the termination modules by termination resistors. Termination modules are located at either end of the bus network. As network messages are broadcast in the form of voltage signals, the network voltage signals are stabilized by the termination resistors. Each termination module has a 120 ohm resistor across the positive and negative bus connection in the termination module. With 2 termination modules on each network and the 120 ohm resistors located in a parallel circuit configuration, the total network impedance, or total resistance, is 60 ohms.
Network termination improves bus message reliability by:
- stabilizing bus voltage.
- eliminating electrical interference.
Gateway Module
The IC is the gateway module, translating HS-CAN to MS-CAN and vice versa. This information allows a message to be distributed throughout both networks. The IC is the only module on this vehicle that has this ability.