Fuel Pump Module
FUEL PUMP MODULESpecial Tool(s)
Special Tool(s):
Removal and Installation
WARNING:
- Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
- Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
- Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
All vehicles
1. Release the fuel system pressure.
2. Release the fuel tank filler cap and position aside.
3. CAUTION: When removing the special tool, the fitting on the end of the hose can become detained by the one-way flapper valve. Carefully remove the hose using a gentle agitating motion to avoid detaching the hose from the fitting.
NOTE: The special tool must be inserted into the fuel tank filler pipe until the fitting on the end of the hose enters into the fuel tank, opening the one-way flapper valve.
Insert the special tool into the fuel tank filler pipe.
4. NOTE: This step will remove approximately 1/8 tank of the fuel from a completely full fuel tank and the majority of any residual fuel in the fuel tank filler pipe.
Attach the fuel storage tanker to the special tool and remove as much fuel as possible from the fuel tank and fuel tank filler pipe.
5. Remove the rear seat lower cushion.
Front wheel drive (FWD) vehicles
6. Remove the 4 screws and the fuel pump (FP) module access cover.
- To install, tighten to 2 Nm (18 lb-in).
All wheel drive (AWD) vehicles
7. Remove the 3 screws and the FP module access cover.
- To install, tighten to 2 Nm (18 lb-in).
All vehicles
8. Disconnect the FP module electrical connector.
9. Disconnect the fuel tube-to-FP module quick connect coupling.
10. NOTE:
- Place absorbent pads on the floor pan in the immediate area in case of fuel spills. Carefully remove the FP module from the vehicle to avoid fuel spillage inside the vehicle.
- Make sure to install a new FP module O-ring seal and lock ring.
Install the special tool, remove and discard the FP module lock ring.
AWD vehicles
11. Carefully lift the FP module out of the fuel tank enough to access and release the internal fuel tube-to-FP module quick connect coupling.
All vehicles
12. CAUTION: The fuel pump (FP) module must be handled carefully to avoid damage to the float arm.
NOTE: The FP module will have residual fuel remaining internally, drain into a suitable container.
Completely remove the FP module from the fuel tank.
13. NOTE:
- Inspect the mating surfaces of the FP module flange and the fuel tank O-ring seal contact surfaces. Do not polish or adjust the O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new FP module or fuel tank if the O-ring seal contact area is bent, scratched or corroded.
- To install, apply clean engine oil to the new O-ring seal.
Remove and discard the FP module O-ring seal.
14. To install, reverse the removal procedure.
- Make sure the alignment tab on the FP module and the fuel tank meet before tightening the FP module lock ring.