Power Steering Line/Hose: Service and Repair
Power Steering Pump to Steering Gear Pressure Line - All Wheel Drive (AWD)Material:
3.0L Engine:
3.5L Engine:
Removal and Installation
CAUTION: When repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.
3.0L and 3.5L engines
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the battery and battery tray. For additional information, refer to Battery.
3. NOTE: Battery mounting bracket removed for clarity.
Disconnect the electrical connectors from the PCM.
^ Detach the wiring harness retainer from the PCM bracket, position harness aside.
4. Remove the lower cowl panel grille.
3.0L engine
5. Remove the pressure line bracket-to-power steering fluid reservoir bolt.
^ Detach the electrical harness retainer from the pressure line bracket.
^ To install, tighten to 9 Nm (80 lb-in).
6. Remove the 2 pressure line bracket-to-engine bolts.
^ Detach the electrical harness retainer from the pressure line bracket.
^ To install, tighten to 9 Nm (80 lb-in).
3.5L engine
7. Remove the pressure line bracket-to-RH valve cover stud nut.
^ Detach the electrical harness retainer from the pressure line bracket.
^ To install, tighten to 9 Nm (80 lb-in).
3.0L and 3.5L engines
8. If equipped detach the engine block heater harness from the power steering pressure line.
9. Remove the pressure line bracket-to-steering gear bolt.
^ To install, tighten to 15 Nm (11 lb-ft).
10. Remove the pressure line-to-power steering pump banjo bolt.
^ Discard the bolt and the 2 seals.
^ To install, tighten to 48 Nm (35 lb-ft).
11. Remove the pressure line-to-steering gear banjo bolt and remove the power steering pressure line.
^ Discard the bolt and the 2 seals.
^ To install, tighten to 55 Nm (41 lb-ft).
12. CAUTION: New banjo bolts and new seals must be installed any time the power steering pressure line is disconnected from the power steering pump and/or the power steering gear or a fluid leak may occur.
To install, reverse removal procedure.
13. Fill the power steering system.