Procedures

GLASS RESEAL - REAR

Material

Material:

1. Remove the C-pillar trim panel and parcel shelf, and lower the headliner.
2. Disconnect the rear window glass electrical connectors.
3. Clean the interior and exterior of the windshield glass surface with glass cleaner.
4. Cut the urethane adhesive applicator tip to specification.







5. NOTE:
- Use either a high ratio, electric or battery-operated caulk gun that applies the urethane with less effort and continuous bead.
- Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.

Apply the urethane adhesive over the top of the existing urethane adhesive.
- Apply the urethane adhesive to the top and sides of the rear glass from the interior of the vehicle.
- Apply the urethane adhesive to the bottom of the rear glass from the exterior of the vehicle.

6. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.

After the urethane cures, check the rear glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.

7. Connect the rear window glass electrical connectors.
8. Install the headliner, parcel shelf and C-pillar trim panels.