Brake Shift Interlock Actuator - Column Shift

Brake Shift Interlock Actuator - Column Shift

Brake Shift Interlock Actuator - Column Shift:

Removal and Installation

1. WARNING: Always deplete the backup power supply before repairing or installing any new front or side air bag supplemental restraint system (SRS) component and before servicing, removing, installing, adjusting or striking components near the front or side impact sensors or the restraints control module (RCM). Nearby components include doors, instrument panel, console, door latches, strikers, seats and hood latches.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least 1 minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).
Failure to follow these instructions may result in serious personal injury or death in the event of an accidental deployment.

Disconnect the battery ground cable. Wait at least one minute before proceeding with the procedure to allow the backup power supply to deplete its energy.
2. Remove the supplemental restraint system (SRS) steering column clockspring.
3. Remove the 3 bolts and remove the coil mounting bracket from the steering column.
^ To install, tighten to 8 Nm (71 lb-inch).





4. Release the clip retaining the brake shift lock actuator and slide the actuator down.





5. Remove the park position switch from the cavity and remove the actuator assembly.





6. To install, reverse the removal procedure.