Crankshaft Rear Seal

Crankshaft Rear Seal








Removal

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the flexplate.
3. Using the special tools, remove the crankshaft oil slinger.





4. Using the special tools, remove the crankshaft rear seal.





Installation

1. NOTE: Lubricate the inner lip of the crankshaft rear seal with engine oil.

Using the special tools, install the crankshaft rear seal.





2. Using the special tools, install the crankshaft oil slinger.





3. Install the flexplate.

4. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.

If equipped with fire suppression system, repower the system.