Test H: The Heated Seat Is Inoperative - Driver

PINPOINT TEST H: THE HEATED SEAT IS INOPERATIVE - DRIVER

Normal Operation
The heated seat module is powered by battery and switched ignition voltage circuits 1048 (LB/WH) and 1040 (RD/BK). The heated seat is activated when the heated seat switch sends a ground signal to one of 2 input circuits into the heated seat module. Input circuit 1020 (DG/VT) activates HI or OFF. Input circuit 1255 (WH/RD) activates LOW or OFF. Once activated, the heated seat module supplies power and ground to the heater mat circuits 1064 (YE/LB) and 1065 (WH/LB) to heat the seat cushion and backrest. The heated seat module monitors circuits 1060 (BK/LB) and 1061 (BN/LB) from the temperature sensor in the cushion heater mat to maintain the seat temperature. The system will remain ON until the module times-out or is switched OFF.

This pinpoint test is intended to diagnose the following:
- Fuse
- Faulty circuit
- Faulty heated seat switch
- Faulty heater mat
- Faulty heated seat module

H1:

H2-H4:

H5-H7:

H7-H9:

H9-H10:

H11-H12:

H13-H14: