Disc Removal and Installation, Rear

Brake Disc

Removal and Installation

Disc Brake System - Exploded View:

1. With the vehicle in NEUTRAL, position it on a hoist.

2. CAUTION: When removing the brake caliper anchor plate, never allow it to hang from the brake hose. Provide a suitable support.

Remove the brake caliper anchor plate bolts and discard. Position the brake caliper anchor plate aside.
^ To install, tighten to 110 Nm (81 lb-ft).
3. Remove and discard the brake disc screw.
^ To install, tighten to 21 Nm (15 lb-ft).
4. Remove the brake disc.
5. To install, reverse the removal procedure, using 2 new brake caliper anchor plate bolts.