Seat Temperature Switch: Service and Repair

SEAT CONTROL SWITCH

Front Seat Backrest (Part 1):

Front Seat Backrest (Part 2):

Driver Front Seat Cushions (Part 1):

Driver Front Seat Cushions (Part 2):

Passenger Front Seat Cushion (Part 1):

Passenger Front Seat Cushion (Part 2):

Exploded View

Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Depower the SRS.

Seats with manual recline
2. Pull out and remove the manual recline handle.

All seats
3. Remove the seat control switch knob and power recline knob (if equipped).
4. Remove the rear screw, pull out on the side and front and separate the side shield.
5. Release the seat control switch wire harness pin-type retainer and remove the seat control switch from the side shield. Disconnect and remove the seat control switch.
6. To install, reverse the removal procedure.
7. Repower the SRS.