Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor

Material:

Turbine Shaft Speed (TSS) Sensor:

Removal
1. Disconnect the turbine shaft speed (TSS) sensor electrical connector.





2. Remove the bolt and the TSS sensor.
- To install, tighten to 10 Nm (89 inch lbs.).
- Check the TSS sensor bore.
- Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.





Installation

1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.

NOTE: Apply thread sealant to the bolt.

To install, reverse the removal procedure.