Brake Fluid Reservoir
Brake Fluid Reservoir - 2.3L and 3.0LMaterial:
Removal and Installation
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
1. Remove the brake master cylinder.
2. Remove the reservoir pin bolt and the brake fluid reservoir.
^ To install, tighten to 17 Nm (13 ft. lbs.).
3. Remove and discard the 2 seals.
4. NOTE: Install new seals. Lubricate the seals with clean specified brake fluid.
To install, reverse the removal procedure.