6 Speed - Automatic Transaxle/Transmission

Transmission Control Module (TCM)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the air cleaner assembly.
4. Disconnect the shift cable end.





5. Disconnect the transmission control module (TCM) electrical connector.





6. Remove the manual control lever nut.





7. Remove the manual control lever.





8. Remove the bolts and remove the TCM.





Installation
1. Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.





2. Install the TCM.
- Tighten to 24 Nm (18 ft. lbs.).





3. Install the manual control lever.





4. Install the manual control lever nut.
- Tighten to 12 Nm (9 ft. lbs.).





5. Connect the TCM electrical connector.





6. CAUTION: Be careful not to bend the manual control lever when installing the shift cable.

Connect the shift cable end.





7. Install the air cleaner assembly.
8. Connect the battery ground cable.
9. Carry out the TCM initial learning procedure. For additional information, refer to Transmission Control Module (TCM) Initial Learning. Transmission Control Module (TCM) Initial Learning

10. Check for correct vehicle operation.