FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Climate Controlled Seat Module

CLIMATE CONTROLLED SEAT MODULE


Front Seat Backrest, Without Fold-Flat (Part 1):






Front Seat Backrest, Without Fold-Flat (Part 2):






Front Seat Backrest, With Fold-Flat (Part 1):






Front Seat Backrest, With Fold-Flat (Part 2):






Driver Seat Cushion (Part 1):






Driver Seat Cushion (Part 2):






Passenger Seat Cushion (Part 1):






Passenger Seat Cushion (Part 2):






Exploded View

Special Tool(s):






Special Tool(s)

Removal

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module. This will reduce the risk of injuring the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.


NOTE:
- If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicates SRS fault.
- When installing a new dual climate control seat module (DCSM), it is necessary to carry out programmable module installation (PMI).
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Before removing the DCSM, carry out the appropriate steps in the programmable module installation (PMI) procedure.
2. Remove the front seat and depower the supplemental restraint system (SRS).
3. Remove the DCSM from the cushion electrical bracket.
- Release the locking wedges and disconnect the 3 DCSM electrical connectors.
- Remove the 2 rivets and DCSM.

Installation
1. Install the dual climate controlled seat module (DCSM) to the seat.
- Position the DCSM to the electrical bracket and install 2 new rivets.
- Connect the 3 DCSM electrical connectors and locking wedges.

2. Install the front seat and repower the SRS. Do not prove out the SRS at this time.
3. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
4. Install the DCSM software data. Carry out the appropriate steps in the PMI procedure.