Exhaust Manifold - RH

Exhaust Manifold - RH

Exhaust Manifold - RH:

Removal

1. WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to Fire Suppression System.

With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the negative battery cable.
3. Rotate the drive belt tensioner clockwise and remove the drive belt.





4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Disconnect the A/C compressor electrical connector.
6. Remove the bolt from the transmission cooler tube bracket.
7. Remove the nut and position aside the transmission cooler tube assembly.
8. Remove the 3 bolts and position aside the A/C compressor.
9. Remove the catalytic converter-to-exhaust manifold nuts and position aside the catalytic converter flange.
10. Remove the 8 nuts, the exhaust manifold and the gasket.
^ Discard the nuts and gasket.

Installation
1. Install a new exhaust manifold gasket, the exhaust manifold and 8 new nuts.
^ Tighten in sequence shown to 25 Nm (18 ft. lbs.).





2. Position the catalytic converter flange and install the catalytic converter-to-exhaust manifold nuts.
^ Tighten to 34 Nm (25 ft. lbs.).
3. Position the A/C compressor and install the 3 bolts.
^ Tighten to 25 Nm (18 ft. lbs.).
4. Position the transmission cooler tube assembly and install the nut.
^ To install, tighten to 9 Nm (80 inch lbs.).
5. Install the transmission cooler tube bracket bolt.
^ To install, tighten to 15 Nm (11 ft. lbs.).
6. Connect the A/C compressor electrical connector.
7. Connect the CKP sensor electrical connector.
8. Rotate the drive belt tensioner clockwise and install the drive belt.





9. Connect the negative battery cable.

10. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System.

If equipped with fire suppression system, repower the system.