Seat Temperature Control Module: Service and Repair

HEATED SEAT MODULE

Front Seat Backrest (Part 1):

Front Seat Backrest (Part 2):

Front Seat Cushion (Part 1):

Front Seat Cushion (Part 2):

Exploded View

Removal

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with an SRS component is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the seat to access the fasteners.
2. Depower the SRS.
3. Remove the affected seat.







4. Disconnect the electrical connector.







5. Insert a flat-bladed screwdriver into the heated seat module bracket and release the locking tab. Remove the heated seat module.

Installation







1. Install the heated seat module in the mounting bracket. Verify that the locking tab is correctly seated.







2. Connect the heated seat module electrical connector.
3. Install the affected seat.
4. Repower the SRS.